SETTING UP THE TRANSMITTER FOR CONDUCTIVE LOCATING Conductive Locating is when there is a direct connection or hookup made to a conductor. This can be done with any Pipehorn transmitter. You must have access to metal of the target conductor (remove all rust, paint, coatings, etc.). Connect the red terminal or clip to the […]
THE PIPEHORN STEPS TO AN ACCURATE LOCATE Following these steps in order will provide good information about the reliability of your locate: Pinpoint – Adjust receiver gain to a steady tone (No Sound: turn it up; Beeping: turning it down). Keeping receiver upright, scan left and right to determine location of strongest signal. Determine Direction – At […]
SETTING UP THE PIPEHORN TRANSMITTER FOR INDUCTIVE LOCATING Inductive Locating is when you apply the tracer signal on the conductor without making a direct electrical contact (without hooking up). It can speed up your locating process if used correctly. Locating inductively is excellent for when you do not have a place to hook up, or if […]
